Common problems of CNC side hole machine

The CNC side hole machine is not allowed to punch holes

Solution 1:

First, find two identical boards. After punching the side holes, insert the wooden pins, and make sure that the two sides are consistent when they are connected in a plane. Then adjust them from reverse to positive, and then plug them in to see if they are exactly the same. If there is a wrong table, then you need to adjust the spindle offset of the side hole machine at this time. When the hole of the side hole machine is not in the middle, turn left or right first to enter the common parameter interface. There is a high-speed laser compensation setting in the upper left corner. If the time is off, subtract the value you are off, and then be sure to click save in the lower right corner. Click on the automatic mode, press the start button, and it will be fine under the punching operation.

Side Hole Drilling Machine

Solution 2:

The CNC side hole machine must clean the guide rail and main shaft every 4 hours (clean with air gun), and oil twice per shift. When lifting the spindle, be sure to loosen the locking screw on the left side of the counter, and then tighten the locking screw after adjustment to prevent the handwheel from being damaged. The power supply of the equipment is three-phase and five-wire, the three-phase live wire is L1 L2 L3, N is the neutral wire, PE ground wire (must be reliably grounded), the working voltage of the equipment should be between 360v-400v, and a voltage stabilizer must be installed if the voltage is unstable.

Drilling Machine Hole Punch

If you encounter problems such as inaccurate drilling, please do not disassemble it privately, and contact the after-sales personnel of the manufacturer in time. The motor protection cover behind the spindle box should be removed in time before use. When the equipment is running, no sundries or people should be placed around it to prevent damage to the motor or injury to people. The frequency converter, controller and other electrical components in the electrical cabinet are not allowed to be disassembled or adjusted without authorization. If there is any problem, please contact the manufacturer in time. When drilling holes in hard wood or solid wood boards, the automatic drilling speed should be appropriately reduced.