Problems encountered during the use of the engraving machine and their solutions

Problems encountered during the use of the engraving machine and their solutions:

1. Check whether the pliers or chucks selected for CNC engraving match? The wear of the pliers or chuck of the woodworking engraving machine will also cause the dislocation of the engraved object. If the pliers or the chuck are too tight, it will also cause the engraved object to pop up when the cutter head contacts the engraved object.

2. For those carved objects with irregular shapes, they seem to be tightly fixed on the surface, and they will shake back and forth when subjected to downward pressure. At this time, you can try to put some waste under the object to increase friction. The other is to keep the packaging that comes with the item. Although the object is irregularly shaped, the packaging that it carries may be very regular and easy to be fixed. Add a small strap to make an irregularly shaped object. Easy to be fixed. Or try tools to fix the regular parts and discard the irregular parts.

3. If the downward pressure on the engraved object is very large, consider whether you use a tapered nose. If the engraving machine's diamond head moves too much during the engraving process, the pressure on the side of the tool will cause the object to be engraved. move. If an incorrect diamond knife is used, it can cause the same problem. A 90 or 100 degree diamond knife will dig into the material and make the material move during the engraving process.

4. Since woodworking engraving machines are often equipped with multifunctional pliers or chucks, and they are made of iron, it is easy to damage the engraved object or make it slip off during the engraving process, so choose some rubber caps or rubber tubes It is helpful to fix the object to be carved.

5. For engraving plastic patterns, you can stick the transfer tape on the back of the engraved object, and then spray the side with the tape on the liquid spray glue, and then stick it on a surface that can be discarded, so as to avoid the use of double-sided Glue, leaving a surface that is difficult to clean. Because the reposting tape is easy to peel and clean. The woodworking engraving machine uses a special engraved belt. One side of this belt is more viscous than the other, so the plate can be moved or replaced at will.

Matters needing attention in engraving machine processing

1. It is forbidden to touch the tip of the knife and iron filings with your hands. The iron filings should be cleaned with iron hooks or brushes;

2. It is forbidden to touch the rotating spindle, workpiece or other moving parts by hand or in any other way;

3. It is forbidden to measure the workpiece, change the speed during the processing, and not to wipe the workpiece with cotton thread, nor to clean the machine tool;

4. During the operation of the milling machine, the operator shall not leave the post, and the machine tool shall stop immediately if it finds an abnormal phenomenon;

5. Check the bearing temperature frequently. If it is too high, you should find relevant personnel to check;

6. During processing, it is not allowed to open the machine protection door;

7. Strictly abide by the post responsibility system, the machine tool is used by a dedicated person, and the use of others must be approved by the person;

8. It is strictly forbidden to put any objects on the beams and baffles of the machine tool to avoid falling and hurting people;

9. It is strictly forbidden to lie on the machine during operation, and it is not allowed to sit or lean on the machine frame.