Determine the fault location by the abnormal noise of the 3axis wood engraving cnc router

Many customers who buy 1325 cnc router machines will have some small faults after using the machine for a long time, and they often cannot judge where the problem is. In fact, most problems can be judged from the abnormal sound of the cnc router machine.

When the cnc router atc 1325 is working, the engraving machine stops one step at a time, and there is noise, which is normal. The atc cnc router 1325 will vibrate at the corresponding frequency, and there is obvious noise. This kind of noise will not affect the normal operation of the machine wood carving knife. The following two abnormal noises are the problems of the machine:

1. The abnormal sound of the spindle motor of the wooden door design cnc router machine may cause the following problems

(1) There is a quality problem in the bearing inside the main shaft.

(2) The life of the main shaft bearing is exhausted.

(3) The wear quality is reduced or damaged, and the spindle needs to be replaced.

2. Abnormal sound when walking in the axial direction

This phenomenon mostly exists in the X-axis, mostly because the axial motor bearing is damaged or the X-axis guide rail lacks lubricating oil, the X-axis is dirty, some balls are worn, the balls fall, etc. At this time, it must be cleaned in time and added lubricating oil, etc.

After purchasing a wooden door cutting machine, customers must pay more attention to the usual maintenance work, because the engraving machine is a long-term work, and the machine wear is inevitable. It is necessary to fill in oil in time and clean up foreign objects on the track.