Precautions for automatic cutting machine operation
You are here: Home » News » Faults and Maintenance » Precautions for automatic cutting machine operation

Precautions for automatic cutting machine operation

Views: 500     Author: Superstar     Publish Time: 2023-01-09      Origin: Site

CNC cutting machine is an important equipment for furniture manufacturers to transform to intelligence and automation, and it can help them improve processing efficiency. However, there are some taboos in the cutting machine that need to be paid attention to, otherwise it will cause damage to the equipment and affect the normal operation.

Matters needing attention when using wood cutting machine:

1. Blindly add something

Adding lubricating oil to the automatic cutting machine is not an easy job, so don't blindly add something inside the machine. The lubrication of a piece of equipment needs to add lubricating oil all the time from the design stage to after the whole equipment is put into use.

wood cnc

ATC Cutting Machine Kit

2. Excessive addition

Lubricating oil is added between the two friction surfaces of the equipment to avoid direct contact, thereby reducing wear. However, some side effects on the lubricating oil surface need to be considered, so the amount of oiling should be strictly controlled. For example, in the reducer, in order to reduce the resistance of the gear movement and the steady rise of the oil, the oil immersion depth of the gear is 1 to 2 teeth high. Therefore it is suggested that the high speed fuel should be smaller.

3. Selection of lubricant

The type and grade of lubricant are selected according to the working conditions, working environment, specific characteristics and lubrication methods of the friction surface of the wood cutting machine.

Equipment with high-speed and strong oil machine functions: the cutting machine should use low-viscosity lubricating oil;

wood router machine

ATC CNC Router 

When the load per unit area of the friction surface of the equipment is large: high-viscosity, good oily lubricating oil should be used;

The smaller the gap between the friction surfaces of the automatic feeder, the lower the viscosity of the selected lubricating oil; the rougher the friction surface, the greater the viscosity of the lubricating oil that should be selected. If the grease taper should be smaller, the oil temperature should be higher. A higher viscosity lubricant should be used.

Therefore, in use, the above principles and test results should be strictly followed to select the appropriate lubricating oil for the equipment. Under normal circumstances, the type of lubricating oil cannot be changed arbitrarily, otherwise the lubrication environment of the equipment will be damaged, resulting in equipment wear and even economic loss.

To sum up, the biggest taboo of using woodworking cutting machine is the selection and addition of lubricating oil. Choose the appropriate lubricating oil according to the characteristics of the equipment, and do not change the type of lubricating oil in the middle, and do not add anything at will, otherwise it may affect the normal operation of the cutting machine.

Note: The above technical content is for reference only