What are the maintenance precautions for computer engraving machine

Because the computer engraving machine utilizes very advanced principles and technologies, users should pay special attention to the maintenance of the equipment. Only by using the correct method of use and doing relevant maintenance work can such advanced equipment play its due role. utility and better maintain its performance. Therefore, when maintaining the computer engraving machine, you need to pay attention to the following aspects.

What are the maintenance precautions for computer engraving machine

1.pay attention to ensure that the ground wire is good

In order to ensure the safety in the process of using the computer engraving machine, it is necessary to do a good job of grounding measures at the beginning to better protect the equipment and the safety of users. The computer engraving machinemanufacturer with good quality and low price also reminds that the grounding wire must use products of special specifications, and to ensure that the power supply can work normally after the grounding, to prevent the external machine from causing the machine tool to jump long, and so on. Very good to extend the life of the equipment.

2. Note that the cooling water should be smooth

Usually computer engraving machines need to use cooling water. At this time, it is necessary to keep the water flowing, because the cooling water can take out the heat generated by the laser tube, and the continuous flow can reduce the temperature to a safe range, otherwise it may be possible Excessive heat can cause damage to the device. Therefore, you should check whether the cooling water of the computer engraving machine is smooth at any time. If you find a problem, you should turn off the equipment in time and carry out maintenance.

3. Pay attention to cleaning and maintain good exhaust

The machine tool is a very important part of the composition of the computer engraving machine, so it is necessary to do a good job of cleaning and maintenance of this part in order to make it run normally. Moreover, since the machine tool of the computer engraving machine belongs to the same high-precision core components, extra care should be taken when using it. For example, after polishing, it must be wiped clean and the bearings should be kept clean and lubricated. At the same time, each bearing should be oiled regularly to make the drive The device is flexible and the relevant inspection work can be done at any time.

The above are several aspects included in the maintenance precautions of the computer engraving machine. In addition, the laser high-voltage button should be used correctly. Good quality computer engraving machine manufacturers also introduce that every time a job is completed, if it is not processed continuously, the "laser high voltage" should be turned off at any time. When the machine is working, it is forbidden for the operator to leave to avoid accidents. It is recommended that the continuous working time does not exceed 5 hours. , you can rest for 30 minutes in between.