Will the CNC router tool wear out too fast?

It is a common problem that the cutting tool of the CNC cutting machine jumps or wears too fast during use, and sometimes the cutting head wears too fast. What are the reasons?

ATC Wood CNC Router

Reasons for tool wear of CNC cutting machine:

1. Tool device

Install the knives correctly, and after installation, double-check it several times. If the installation of the equipment is unqualified, but it is started to use again, it will cause damage to the equipment and reduce the service life of the machine.

2. CNC router tool is not clean

Especially the internal debris, no matter how small the debris is not cleaned in time, it will increase the damage rate of the tool. At the same time, the conflict force increases, and the temperature of the machine and the tool will heat up, forming a vicious circle. The saw load of CNC cutting machine increases, reducing its service life.

3. The cutting material is not clean

The plate must be cleaned before cutting. If the impurities contain substances with high hardness, it will cause great damage to the cutting tool of the CNC cutting machine.

Wood Cutting Machine Kit

4. Carefully operate the cutter of the CNC cutting machine

In order to avoid the bumps and pits caused by accidental falling on the ground, the tool surface of the CNC cutting machine is not lubricated enough, which increases the collision force and increases the machine loss and tool loss.

5. The cutting tool of the machine works too long at a time

In order to speed up production, the tool load of the CNC cutting machine will increase, resulting in conflict heat, changes in physical properties, and rapid wear.

The above is the summary of the reasons for the excessive wear of the cutting tool of the CNC cutting machine. It is necessary to maintain and check the cutting tools regularly. Only in this way can we ensure good work efficiency and improve processing quality.