CNC cutting machine needs to master these daily solutions

During the use of the CNC cutting machine, there are sometimes some machine failures. Do you know how to solve the machine failure?Today, Superstar CNC summarizes the following points for you:

1. What should I do if the machine is not powered on when the CNC cutting machine is turned on?

There are many reasons why the machine is not powered on when the CNC cutting machine is turned on. There are the following reasons for your reference:

Check whether the start button wire is connected well and whether the button is burnt; check whether the AC contactor is short-circuited or burnt; check whether the emergency stop switch is turned on; check whether the fuse is burnt.

2. The machine is not powered on when the CNC cutting machine is turned on.

Check whether the start button wire is connected well and whether the button is burnt; check whether the emergency stop switch is in the pressed state; check whether the fuse is in good condition, and whether the internal wire is virtually connected. When the button moves, the spindle only goes in one direction.

3. Limit phenomenon occurs during the engraving process.

Check whether the engraving path exceeds the engraving range; check whether the limiter is in good condition.

4. When the CNC router cutting machine starts and resets, it beeps or the limit switch is always good or bad.

The top rod can not reach the limit switch, just correct it. The drive line is not in good contact, try to fix the drive line firmly. The limit switch line is not connected properly, just connect the line. The limit switch is broken, replace it.

5. The knife is often broken when carving hard materials.

When engraving hard materials, it is necessary to set different engraving parameters and use different tools to select suitable lubricants according to different materials.

The above are some of the daily solutions for CNC wood cutting machinesummarized by Superstar CNC, I hope to help everyone. If you also need CNC cutting machine equipment, please contact us on the official website.