How to solve the dislocation of CNC woodworking engraving machine

1. The problems of the CNC woodworking engraving machine itself: a certain part on the machine tool is faulty or loose, and there are impurities on the surface; the coupling is loose or broken; the guide rail and screw rod have not been cleaned and refueled for a long time; the machine tool line will be broken. Misalignment occurs. The connection of each part of the control line is poor (control line transmission line). Solution: Disconnect all connections and re-install them.

2. Problems with the drive of the CNC woodworking engraving machine: there is a problem with the layout of the drive itself or the original electronic equipment, which will cause dislocation. It means that the drive is not completely broken; if it is misaligned at the beginning of carving, it means that the drive is completely broken. Solution: Patch the drive or replace the drive.

3. Whether the way of engraving the software is correct or not; the CNC engraving machine manufacturer checks the gap size of the screw of the CNC woodworking engraving machine and whether the fastening screws of the polished rod are loose; check whether the setting of the software parameters is correct; check whether the ground wire is connected well ;

4. Whether the computer of the woodworking engraving machine has a virus or is incompatible with others or interferes with others, it is usually recommended that no brand machine is required, and the chassis can be simply assembled; whether the coupling above the front of the water-cooled spindle motor is loose or damaged, you can check whether it is tightened by hand or replace;