What should I do if the motor of the woodworking cutting machine has abnormal noise

The servo motor of the CNC cutting machine is mainly responsible for the operation driving force of the whole equipment. Usually, it should be checked and checked. If there is any abnormality, it should be shut down immediately for checking to prevent the delay of common faults and lead to higher damage.

Introduce in detail the solution to the abnormal noise of the cutting machine motor.

First of all, we should clarify whether the CNC cutting machine is overloaded, which will cause great damage to the equipment, not only will lead to common faults of the motor, but also various components will be damaged under overload pressure. Therefore, it is strictly forbidden to overload the CNC cutting machine, effectively control its working conditions, and make it more manufacturer's service items for everyone.

Then there is the inspection inside the motor, if there is any problem, it should be repaired or replaced. Note that if you don't know the equipment, you can't disassemble it casually to prevent higher damage.

In addition to the problem of the abnormal noise of the motor, the motor of the CNC cutting machine also has the problem of motor heating. At this time, it is necessary to check whether the centrifugal water pump is working normally and whether the cooling circulating water is low. Its heat dissipation is natural, and overloading will also cause the device to heat up, so you should pay attention to this.

The above is a detailed introduction to the common faults of the CNC cutting machine motor, and I look forward to helping you.